Ace & AE servo's in the 808

Piraterc Forum » ASK THE PRO'S » Xray Team Drivers » Tips & Tricks of the Trade (Moderator: Bren) » Topic: Ace & AE servo's in the 808

Pages: [1] Go Down

« previous next »

	Author	Topic: Ace & AE servo's in the 808 (Read 271 times)
0 Members and 1 Guest are viewing this topic.

Bren

Moderator
Trade Count: (0)
Master

Karma: +1/-0
Offline

Offline

Posts: 360

Ace & AE servo's in the 808

« on: February 09, 2010, 06:57:36 AM »

The std xray horns do not fit the ace servo well, the futaba is the closest fit but loose on the spline & will slip.
You will need to run the std ace horn & adapt.
Put a small spacer between the horn & spline to lift it up. 2mm is sufficient & keeps enough strength.
Dremel away the webs on the underside of the horn, this again give more clearance & a smooth surface.
The lower brake mount remove the step again it gives clearance.
All of this is a slow process in remove a bit and retry so not to remove more than is needed.


	Logged

Nemo racing, CML, SMD, Model cars Reading, Kifopaint & Promotions Manager Piraterc

Pages: [1] Go Up

Piraterc Forum » ASK THE PRO'S » Xray Team Drivers » Tips & Tricks of the Trade (Moderator: Bren) » Topic: Ace & AE servo's in the 808

« previous next »

Jump to: